Direct and Versu models added to the N and T Series

20.10.2008

Valtra’s Versu and Direct models are extremely simple to use. There is no gear lever in the already spacious cab. The stepless transmission is controlled by a lever on the armrest. Powershift steps on the five-speed transmission are shifted using three buttons ergonomically situated on the driver’s armrest. With the stepless transmission, the driver selects the gear range using a lever, the speed using the throttle pedal and the direction using the forward/reverse shuttle, operated with his or her left arm. Driving a tractor does not get any easier.

Valtra’s traditional features have also been further refined and many additional features added on the new tractor models. Both Versu and Direct models are as fast and efficient working in reverse using their TwinTrac reverse-drive systems as they are working forwards. As with all Valtra tractors, the Versu and Direct models can also be operated in extreme cold Nordic conditions, since their transmissions are fully disengaged from the engine during start-up. Both new models are available with ground speed PTO, which opens up new opportunities for forest, peat, limestone and transport contractors. The Versu model also offers creeper speeds as standard.

The new transmissions are extremely efficient. A 50-km/h transmission and fuel-conserving EcoSpeed function are naturally also available.

More power and especially torque

The N122 model is powered by AGCO Sisu Power’s (former Sisu Diesel) 44 CWA engine, the N142 model by a 49 CWA-4V engine, T132-T172 models by 66 CTA-4V engines and T182-T202 models by 74 CTA-4V engines. All these models have slightly more power and 5 to 17 percent more torque than their previous corresponding models. Torque rise has been increased considerably compared to earlier models. All Versu models are also available with transport boost for additional power on roads, while the biggest models have Sigma Power for heavy PTO work. The T162e Versu is a fuel-efficient EcoPower low-rpm model. Valtra and AGCO Sisu Power have co-operated for over 50 years in developing transmissions and engines, which ensures that the main components work perfectly together.

The new tractors come with load-sensing hydraulics as standard. The standard output is 115 l/min, but a 151 l/min pump is available for demanding implement combinations. The hydraulic and transmission oils are separate. Heat exchange occurs between the two oils, allowing the transmission oil to heat up the cold hydraulic oil, which in turn cools the hot transmission oil during road transport.

Heavy-duty linkages and an industrial front axle with brakes are available for demanding tasks. The HD linkages have a lifting capacity of 85 kN and are available on T182 and T202 models. The industrial front axle can be specified on both the N and T Series, and on the T Series it features optionally two brake discs per side. The T Series is available with either a 50 kN or 35kN liftable front linkage. Either linkage can be fitted together with Aires front axle suspension, and the 35kN linkage can also be fitted together with a front loader. When using a front loader, a hydraulics assistant automatically increases rpm to help loading work in Direct models.

The new Versu and Direct models are easy to service, providing easy access to daily inspection points. These tractors will spend their time on fields, in forests and on the road – not standing in the garage.

Enhanced driving comfort for long days

The new T and N Series Versu and Direct models can be most easily identified by their new engine covers and rear mudguards. The new T Series also has a cast-iron frame and separate fuel tank, unlike the previous generation. The number 2 at the end of the model number refers to the second generation of the N and T Series.

The changes to the exterior are not just cosmetic. The new air vents improve engine cooling, while the new rear mudguards keep the entrance to the cab clean even in the muddiest conditions.

The upgraded cab allows drivers to work long days safely and comfortably. Without gear levers the cab is noticeably more spacious than before. The upper and lower side panels have also been redesigned to make them even more user friendly. Despite the optional automatic air conditioning system, it is now possible to also open the side window.

An even wider range of tractors

The new Versu and Direct models expand Valtra’s range of tractor models. The N and T Series can still be specified as HiTech models with three powershift gears. The new transmission options offer customers the possibility to customise their tractors even more according to their specific needs.

Production of the new T and N Series Versu models will be phased in during the first half of 2009, while production of T and N Series Direct models will begin in the middle of 2009.

 

Versu and Direct models:

 Max. power hp (ISO 14396)  Max. torque Nm (ISO 14396)

N122  137     560   
N142  152     600

T132  141     580
T152  156     630
T162e  159     675/(790 with EcoPower)
T172  177     715
T182  186     750
T202  200     800 Versu/750 Direct

 

Valtra Inc.

More information:
Matti Kallio, Manager, Product Management, +358 40 861 2507, matti.kallio@valtra.com
Luis Teles, Director, Sales and Marketing, +358 40 4873 248, luis.teles@valtra.com

www.valtra.com

Valtra Inc. develops, manufactures, markets and services Valtra tractors. Valtra is the leading tractor manufacturer in the Nordic countries and the second most popular brand in Latin America. Net sales in Europe, the Middle East and Africa (EAME) in 2007 amounted to 523 million euros and the number of employees to 1050. Total production in Finland and Brazil amounted to 21,600 tractors. Valtra is a worldwide brand of AGCO Corporation.

 

Atgal

Pictures